Table of Contents
Advertisement
Question and Answer
Question 1: When use External VGA CARD and using DIMM in SDRAM2 (BANK2)
only the system don't have the screen.
Ans:
Change the DIMM to SDRAM1 to solve this problem.
Question 2:
When using Ti 32MB DIMM 2pcs, no screen on system.
Please change the "SDRAM CAS Latency" setting in BIOS CHIPSET
Ans:
FEATURES SETUP the default value is "3T", Please change to "2T",
Please follow the step to change the setting
step 1. Only plug one pcs DIMM let the system boot up.
step 2. Press <DEL> enter CMOS SETUP UTILITY to set up.
step 3. Choice "CHIPSET FEATURES SETUP"
step 4. Setting "SDRAM CAS LATENCY" value to "2T"
step 5. SAVE CMOS and EXIT
step 6. Power Off and Plug another DIMM, Power On again.
Question 3:
When Install OS/2 REV:3 will SCSI Hard Disk and IDE CDROM plug
in Slave Mode, the system will hang up.
Ans:
Please change the IDE CDROM DRIVER to Master Mode to solve this
Problem.
Question 4: After Install Win 95 have "?" mark in PCI Universal Serial Bus Device
item when you check Device Manager icon in control panel.
You can solve the problem "Microsoft Supplemental 3 for Windows 95"
Ans:
Utility, because Microsoft build in SIS USB Device Driver after
Supplemental 3 utility. Before th is version Windows 95 can not
recognize USB Device in SIS 5598 chip set.
Chapter 5
47
Advertisement
Table of Contents
