MSI TX98 Manual page 25

Disabled: BIOS will not search for the type of floppy disk drive by track
number.
Note that there will not be any warning message if the drive
installed is 360K.
•
Boot Up NumLock Status: The default value is On.
On: Keypad is number keys.
Off: Keypad is arrow keys.
•
Boot UP System Speed: It selects the default system speed-the speed that
the system will run at immediately after power up.
High : Set the speed to high.
Low :
Set the speed to low.
NOTE: The board default value is LOW in the field. Boot the system to controller turbo
or De-turbo by Onboard (Turbo Switch).
•
Gate A20 Option: The default value is Fast.
Normal :
The A20 signal is controlled by keyboard controller or chipset
hardware.
Fast :
Default: Fast. The A20 signal is controlled by Port 92 or chipset
specific method.
•
Memory Parity Check: The default setting is Disable.
Allows system to check memory's parity.
Enable :
•
Typematic Rate Setting: This determines the typematic rate.
Enabled :
Enable typematic rate and typematic delay programming.
Disabled : Disable typematic rate and typematic delay programming. The
system BIOS will use default value of this 2 items and the default
is controlled by keyboard.
•
Typematic Rate (Chars/Sec):
6 : 6 characters per second
10 : 10 characters per second
15 : 15 characters per second
24 : 24 characters per second
•
Typematic Delay (Msec): When holding a key, the time between the first and
second character displayed.
8 : 8 characters per second
12 : 12 characters per second
20 : 20 characters per second
30 : 30 characters per second
23