MSI TX98 Manual page 35

Auto :
BIOS will automatically detect the Onboard Primary Master PCI
IDE HDD Accessing mode.
Mode0~4 : Manually set the IDE Accessing mode.
•
IDE Primary Slave PIO: The default value is Auto.
Auto :
BIOS will automatically detect the Onboard Primary Slave PCI IDE
HDD Accessing mode.
Mode0~4 : Manually set the IDE Accessing mode.
•
IDE Secondary Master PIO: The default value is Auto.
Auto :
BIOS will automatically detect the Onboard Secondary Master PCI
IDE HDD Accessing mode.
Mode0~4 : Manually set the IDE Accessing mode.
•
IDE Secondary Slave PIO: The default value is Auto.
Auto :
BIOS will automatically detect the Onboard Secondary Slave PCI
IDE HDD Accessing mode.
Mode0~4 : Manually set the IDE Accessing mode.
•
Onboard FDC Controller: The default value Enabled.
Enabled : Enable the Onboard floppy drive interface controller.
Disabled : Disable the Onboard floppy drive interface controller. When use
On-card ISA FDC's controller.
•
Onboard UART1: This field allows the user to select the serial port. The default
value is Auto.
COM1 :
Enable Onboard Serial port 1 and address is 3F8H.
COM2 :
Enable Onboard Serial port 1 and address is 2F8H.
COM3 :
Enable Onboard Serial port 1 and address is 3E8H.
COM4 :
Enable Onboard Serial port 1 and address is 2E8H.
Disabled : Disable Onboard CHIP's Serial port 1.
•
Onboard UART2: This field allows the user to select the serial port. The
default value is Auto.
COM1 :
Enable Onboard Serial port 2 and address is 3F8H.
COM2 :
Enable Onboard Serial port 2 and address is 2F8H.
COM3 :
Enable Onboard Serial port 2 and address is 3E8H.
COM4 :
Enable Onboard Serial port 2 and address is 2E8H.
Disabled : Disable Onboard CHIP's Serial port 2.
•
Onboard UART 2 Mode: The default setting is Standard.
HPIR:
HP standard mode IR.
ASKIR:
ASK standard mode IR.
•
IR function duplex:
33