Table of Contents
Advertisement
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
Important:
Before installing the spiker, the
traction unit must be equipped with the Front
Weight Kit.
1
Mounting the Spiker
Parts needed for this procedure:
1
Spiker assembly
Procedure
Note:
Determine the left and right sides of the
machine from the normal operating position.
1.
Remove any attachment from the rear of the
machine.
2.
Back the traction unit into position in front of
the attachment adapter. Lower the traction unit
adapter.
Note:
Ensure that the locking lever is pivoted to
the left (unlocked position) as viewed from the
rear of the machine
Description
Spiker assembly
No parts required
No parts required
(Figure
3).
Qty.
1
Mount the spiker.
–
Adjust the link assembly.
–
Finish the setup.
1. Attachment adapter
3.
Raise the traction unit adapter into the
attachment adapter.
4.
Pivot the locking lever to the right to lock the
adapters together.
2
Use
Figure 3
2. Locking lever
g003781
Advertisement
Table of Contents
