Setting The North Position - American Dynamics SpeedDome Ultra VII RAS917LS Configuration

Setting the North Position

Direction Indicators permit you to understand the approximate pointing position of the dome to an
established reference point. This reference point is called "North" and may correspond to magnetic
north (if it is known) or some other landmark or fixture. When the dome is initially installed, "North"
defaults to a pre-defined position (0° pan/tilt). You may program the "North" position to be any point
along the dome's pan axis (also called azimuth).
For more information about Direction Indicators, see Chapter 5.
Programming the North Position
1. Select Alarms/Areas/Home/Presets/PZ from the Dome Configuration Menu.
2. Select Set North Position.
The Set North Position screen appears:
3. Point the dome to the new North position. When satisfied with the view, save the setting, or
cancel the change.
4. The Alarms/Areas/Home/Presets/PZ screen appears. Select Exit. The Dome Configuration
Menu appears. Continue with What To Do Next on page 4–20.
4–8
SET NORTH POSITION
PAN to new north position
ZOOM to mark north position
FOCUS quits w/o changing
SpeedDome Ultra VII Day/Night Operator's Manual