Sending The Picture - Icom ID-52A Advanced Manual

14
SHARE PICTURES FUNCTION

Sending the picture

Step 1. Selecting a picture to send
L You can retransmit the picture in the TX PICT HISTORY
screen� (p� 14-7)
L When you transfer the picture through Bluetooth, it is
set to "TX Picture�" If it is not necessary to change, go to
"Step 2� Sending the picture�"
[MENU] > PICTURE
1� Push [MENU]�
2� Select "PICTURE�"
3� Push D-pad() to select the TX Picture zone, and
then push [ENT]�
4� Push [ENT] again�
5� Select "TX Picture�"
6� Rotate [DIAL] to select a picture�
L You cannot view a picture if it is not in a supported
format (p� 14-2), or is corrupted�
7� Push [ENT]�
8� Set "Picture Size," "Picture Quality," and
"Receiver�"
L See page 14-6 about each setting item�
9� To close the TX PICTURE SET screen, push
[MENU]�
Step 2. Sending the picture
1� Push [QUICK]�
2� Select "Picture TX�"
3� Select "Single TX" or "Repeat TX�"
4� Hold down [PTT] to transmit�
L The picture is sent while transmitting�
5� Release [PTT] to receive�
Sending a picture using the DV Fast Data
function
Select "<<TX All>>" in step 2 to send a picture using
the DV Fast Data function�
L DO NOT select "<<TX All>>" when you send a picture
to other transceivers that can receive only slow speed
data�
L While transmitting voice audio by holding down [PTT] on
the microphone, the transceiver automatically changes
to the Slow Speed Data mode�
14-5
Displayed while the Share
Pictures function is ON�