Icom ID-52A Advanced Manual page 74

5
D-STAR OPERATION (ADVANCED)
Entering new information into the repeater list
D Entering new information into the repeater list
Step 7. Changing the repeater group
L The repeater group that is selected in Step 1.
Selecting the repeater group is displayed� You can
skip this setting and go to the next item� To change
the group, follow the steps described below�
1� Select "GROUP�"
2� Select the repeater group� (01 ~ 50)
Step 8. Setting "USE(FROM)" to be used as an
access repeater
L You can use the entered repeater as an access
repeater when using the DR function� When not
using as an access repeater, select "NO," and go
to Step 15. Selecting the position data accuracy
level� In that case, the entered repeater is not
displayed in "FROM" on the DR screen�
1� Select "USE(FROM)�"
2� Select "YES" to use the repeater as an access
repeater�
Step 9. Entering the access repeater frequency
1� Select "FREQUENCY�"
2� Rotate [DIAL] to enter the repeater frequency�
L Push D-pad() to move the cursor�
3� After entering, push [ENT]�
Step 10. Selecting the Duplex direction
L When Step 2. Selecting the communication type
is set to "DV Simplex" or "FM Simplex," this item is
not displayed�
L "DUP–" is automatically set when the access
repeater frequency is entered in Step 9. Entering
the access repeater frequency� If necessary, you
can change the Duplex direction�
1� Select "DUP�"
2� Select a Duplex direction�
• OFF: Turn the duplex function OFF�
• DUP–: The transmit frequency shifts down from the
receive frequency by the offset amount�
• DUP+: The transmit frequency shifts up from the
receive frequency by the offset amount�
Step 11. Entering the frequency offset
L When Step 2. Selecting the communication type
is set to "DV Simplex" or "FM Simplex," this item is
not displayed�
L The offset value* is automatically set when the
access repeater frequency is entered in Step
9. Entering the access repeater frequency� If
necessary, you can change the frequency offset�
* The default value differs, depending on the transceiver
version�
1� Select "OFFSET FREQ�"
2� Rotate [DIAL] to enter the frequency offset
(0�000�00 ~ 59�995�00 MHz)�
L Push D-pad() to move the cursor�
3� After entering, push [ENT]�
5-33