Providing Air Flow and Minimum Recommended Clearances
•
Swit ches operat ing in an environment at or above 65° C require air f low.
•
Swit ches operat ing in an environment below 65° C do not require airf low.
•
When mount ing t he chassis on a f lat service (e. g. , t abl e) be sure t hat t he t op of t he swit ch,
wit h t he larger heat sinks, is f acing out and away f rom t he mount ing surf ace.
•
Be sure t o ref er t o minimum recommended clearances provided in t he t abl e below.
Minimum Recommended Clearances
Top (Rack mount )
Top (Tabl e mount )
Bot t om (Rack mount )
Bot t om (Table mount )
DNV Inst all at ions
Sides
Rear
Front
Items Included
Depending on your order t he f ollowing it ems may be included:
•
OmniSwit ch chassis wit h power supplies and modules
•
Count ry specif ic power cord(s)
•
Cover Panels
•
Rack Mount Bracket s
•
Product Document at ion and Training Cards
•
DB9-RJ45 Connect or
OmniSwit ch 6865 Hardware Users Guide
0. 875 inches (1/ 2 RU) f or swit ches operat ing in an ambient
t emperat ure below 65° C;
1. 75 inches (1 RU) f or swit ches operat ing in an ambient t emperat ure
at or above 65° C. (See import ant air f low requirement s out lined
above. )
0. 875 inches; f or t able mount ing, be sure t o inst all t he mount ing
bracket s as described in t he sect ion,
Power Supply Tray Assembly. "
No minimum clearance required. However, be sure t hat t he bot t om of
t he chassis is not in direct cont act wit h any equipment below.
0. 875 inches; f or t able mount ing, be sure t o inst all t he mount ing
bracket s as described in t he sect ion,
Power Supply Tray Assembly. "
0. 875 inches (1/ 2 RU) f or OS6865-U12X and OS6865-P16X t hat require
a DNV power supply cover, operat ing bet ween -40° C t o 55° C (-40° F t o
131° F).
1. 75 inches (1 RU) f or OS6865-U28X t hat requires a DNV power supply
cover, operat ing bet ween -40° C t o 55° C (-40° F t o 131° F).
2 inches
6 inches
6 inches
" Preparing t he Chassis and
" Preparing t he Chassis and
.
21