Mercedes-Benz C-Class 2014 Owner's Manual page 444

Put hub cap : in position and turn the
X
centre cover clockwise until you feel and
hear hub cap : engage.
Make sure that hub cap : is fitted
X
securely.
Light-alloy wheel with aluminium hub cap
Vehicles with aluminium hub cap:
To remove: take socket ; and wheel
X
wrench = from the vehicle tool kit
( page 407).
Y
Position socket ; on hub cap :.
X
Attach wheel wrench = to socket ; and
X
loosen hub cap : anti-clockwise.
Remove hub cap :.
X
To fit: before fitting, check hub cap : and
X
the wheel area for soiling and clean if nec-
essary.
Put hub cap : in position and turn until it is
X
in the right position.
Position socket ; on hub cap :.
X
Attach wheel wrench = to socket ; and
X
tighten hub cap :.
The tightening torque must be 25 Nm.
i
Note that the hub cap should be tight-
ened to the specified torque of 25 Nm.
Mercedes-Benz recommends that you have
the hub cap fitted at a qualified specialist
workshop.
Changing a wheel
Using wheel wrench =, loosen the bolts on
X
the wheel you wish to change by about one
full turn. Do not unscrew the bolts com-
pletely.
The jacking points are located just behind the
front wheel arches and just in front of the rear
wheel arches (arrows).
Vehicles with AMG equipment: to protect
the vehicle body, the vehicle has covers fitted
next to the jacking points on the outer sills.
Vehicles with AMG equipment: fold
X
cover ? upwards.
441
Z