Mercedes-Benz C-Class 2014 Owner's Manual page 405

Care
402
Make sure that the vehicle is stationary and
X
that the key is in position 2 in the ignition
lock.
To open the cover of the 360° camera:
X
with COMAND Online or Audio 20 activa-
ted, call up the vehicle menu: press the
Ñ button.
To switch to the menu bar: slide ¬ the
X
controller.
To select System System settings
X
press the controller.
To select the
X
the controller.
To select Open camera Open camera cover
X
press the controller.
The cover of the 360° camera opens.
To clean the 360° camera: clean camera
X
lens : with clear water and a soft cloth.
If you drive at speeds above 30 km/h or with
the key in position 0 or 1 in the ignition lock,
the cover of the 360° camera closes auto-
matically.
Cleaning the exhaust tail pipes
G WARNING
The exhaust tail pipe and tail pipe trim can
become very hot. If you come into contact
with these parts of the vehicle, you could burn
yourself. There is a risk of injury.
Always be particularly careful around the
exhaust tail pipe and the tail pipe trim. Allow
these components to cool down before touch-
ing them.
! Do not clean the exhaust pipe with acid-
based cleaning agents such as sanitary
cleansers or wheel cleaners.
Impurities combined with the effects of road
grit and corrosive environmental factors may
cause flash rust to form on the surface. You
can restore the original shine of the exhaust
pipe by cleaning it regularly, especially in win-
ter and after washing.
settings: turn and
360° camera 360° camera: turn and press
cover: turn and
Clean the exhaust pipe with a care product
X
tested and approved by Mercedes-Benz.
Cleaning the trailer tow hitch
H Environmental note
Dispose of oily and greasy cloths in an envi-
ronmentally-responsible manner.
! Do not clean the ball coupling with a high-
pressure cleaner. Do not use solvents.
! Please note the care instructions in the
trailer coupling manufacturer's operating
instructions.
The ball coupling must be cleaned if it
becomes dirty or corroded.
Remove rust on the ball, e.g. with a wire
X
brush.
Remove dirt with a clean, lint-free cloth or a
X
brush.
After cleaning, lightly oil or grease the ball
X
coupling.
Check that the vehicle's trailer tow hitch is
X
working properly.
i
You can also have the maintenance work
on the ball coupling and the trailer tow hitch
carried out by a qualified specialist work-
shop.
Interior care
Cleaning the display
! For cleaning, do not use any of the fol-
lowing:
alcohol-based thinner or petrol
R
abrasive cleaning agents
R
commercially-available household clean-
R
ing agents
These may damage the display surface. Do
not put pressure on the display surface
when cleaning. This could lead to irrepara-
ble damage to the display.