Mercedes-Benz C-Class 2014 Owner's Manual page 413

Flat tyre
410
G WARNING
In the following situations, the tyre sealant is
unable to provide sufficient breakdown assis-
tance, as it is unable to seal the tyre properly:
there are cuts or punctures in the tyre
R
larger than those mentioned above.
the wheel rim is damaged.
R
you have driven at very low tyre pressures
R
or on a flat tyre.
There is a risk of an accident.
Do not drive any further. Contact a qualified
specialist workshop.
WARNING
G
The tyre sealant is harmful and causes irrita-
tion. It must not come into contact with your
skin, eyes or clothing or be swallowed. Do not
inhale TIREFIT fumes. Keep tyre sealant away
from children. There is a risk of injury.
If you come into contact with the tyre sealant,
observe the following:
Rinse off the tyre sealant from your skin
R
immediately with water.
If the tyre sealant comes into contact with
R
your eyes, immediately rinse them thor-
oughly with clean water.
If tyre sealant is swallowed, immediately
R
rinse your mouth out thoroughly and drink
plenty of water. Do not induce vomiting,
and seek medical attention immediately.
Immediately change out of clothing which
R
has come into contact with tyre sealant.
If an allergic reaction occurs, seek medical
R
attention immediately.
! Do not operate the tyre inflation com-
pressor for longer than eight minutes at a
time without a break. It may otherwise
overheat.
The tyre inflation compressor can be oper-
ated again once it has cooled down.
Comply with the manufacturer's safety
instructions on the sticker on the tyre infla-
tion compressor.
Using the TIREFIT kit
Do not remove any foreign objects which
X
have penetrated the tyre, e.g. screws or
nails.
Remove the tyre sealant bottle, the accom-
X
panying TIREFIT sticker and the tyre infla-
tion compressor from the stowage space
under the boot floor (
Affix part : of the TIREFIT sticker within
X
the driver's field of vision.
Affix part ; of the TIREFIT sticker near the
X
valve on the wheel with the defective tyre.
Pull plug ? with the cable and hose A out
X
of the housing.
Screw hose A onto flange B of tyre seal-
X
ant bottle :.
Place tyre sealant bottle : head down-
X
wards into recess ; of the tyre inflation
compressor.
page 407).
Y