Bosch AutoCook MUC6 Series Instruction Manual page 17

3. Close the appliance. Press the lid
down for this purpose until it clicks into
place and close the pressure locking
handle (N).
An audible signal sounds. The steam
pressure function is switched on.
4. Press button B to access function
selection mode.
The desired preparation programme is
selected in function selection mode and all
settings of the appliance are made. Button B
and the indicators [ мой режим ] (my mode)
and [ K ] are permanently lit. Button G
flashes. "00:00" is shown in the display.
Note: If no input is made on the control
panel within 5 minutes, the appliance
automatically switches to standby mode.
5. Keep pressing button D until the
desired preparation programme is
selected.
The corresponding LED lights up in the
control panel and the pre-configured
preparation time for the selected
preparation programme flashes. The
indicator "low steam pressure" [ K ] or
"high steam pressure" [ L ] lights up. Press
button L to switch between [ K ] and [ L ].
Note: If [ K ] or [ L ] does not light up, the
steam pressure function is not available for
the selected programme.
6. Press button G to start the preparation
programme.
The appliance heats up the pan until the
pre-configured steam pressure is reached.
During the heating phase, lines that light up
in a clockwise direction appear in the display.
Once the pre-configured steam pressure
is reached, the lines go out and the
preparation time is shown in the display.
The preparation process starts automati-
cally. The preparation time counts down.
Once the preparation time is completed,
an audible signal sounds, the display
flashes and shows "P". Steam automatically
escapes from the appliance intermittently
to reduce the pressure in the appliance
interior.
W Risk of scalding!
Never bend over the appliance while steam
is escaping from it!
When the pressure in the appliance interior
has been completely reduced, the indicator
[ готово ] (finished) and button G light
up or the keep warm function is activated.
X "Keep warm function" see page 20
A rectangle lights up in the display (dotted
lines). The preparation programme is
completed.
Preparation en
17