After the event occurs, when the system is active, a message regarding fuel cutoff is displayed. Turn the ignition switch from ignition AVV/START or MAR/ON/

RUN to ignition STOP/OFF/LOCK. Carefully check the vehicle for fuel leaks in the engine compartment and on the ground near the engine compartment and fuel

tank before resetting the system and starting the engine.

Depending on the nature of the event the left and right turn signal lights, located in the instrument panel, may both be blinking and will continue to blink. In order

to move your vehicle to the side of the road, you must follow the system reset procedure.

Customer Action

NOTE:

Each step MUST BE held for at least two seconds

1. Turn ignition STOP/OFF/LOCK. (Turn Signal Switch Must be placed

in Neutral State).

2. Turn ignition MAR/ON/RUN.

3. Turn right turn signal switch ON.

4. Place turn signal in neutral state.

5. Turn left turn signal switch ON.

6. Place turn signal in neutral state.

Customer Will See