Table of Contents
Advertisement
Figure 9.23
• Press the 17 button to set "2 -°-", then
press 13 to confirm the 2 and go to the
next segment.
• Press the 17 button to set "2°7 -", then
press 13 to confirm the 7 and go to the
next segment.
• Press the 17 button to set "2°7°5", then
press 13 to confirm the 5 and go back to
the list of parameters.
• The code P10 appears on the display, in-
dicating entry into "parameter P10" (Fig-
ure 9.24).
Figure 9.24
• By using buttons 16 or 17 (Figure 9.21)
it is possible to modify the value of pa-
rameter P10 (00=M270V.2025 SM or
01=M270V.2530 SM) (Figure 9.25).
Figure 9.25
• Press 13 or 14 (Figure 9.21) to confirm the
value entered and return to the list of pa-
- 68 -
MAINTENANCE
RESET
bar
RESET
bar
RESET
bar
rameters (Figure 9.24).
• Press the 18 button (Figure 9.21) to exit
"programming mode".
• Enter "programming mode" by holding
down buttons 18 and 19 for 5 seconds
at the same time (Figure 9.21). The code
P00 appears on the display, indicating en-
try into "parameter P00" (Figure 9.26).
Figure 9.26
• Scroll through the various parameters us-
ing 13 or 14 until the LCD display shows
the message Cod, indicating entry into
"parameter Cod" (Figure 9.27), and then
displays three dashes "- - -".
Figure 9.27
• Press the 17 button to set "1 - -", then
press 13 to confirm the 1 and go to the
next segment.
• Press the 17 button to set "1°9 -", then
press 13 to confirm the 9 and go to the
next segment.
• Press the 17 button to set "1°9°8", then
press 13 to confirm the 8 and go back to
the list of parameters.
• The code A01 appears on the display, in-
dicating entry into "parameter A01" (Fig-
ure 9.28).
RESET
bar
RESET
bar
Advertisement
Table of Contents
