Table of Contents
Advertisement
Congratulations on choosing this product.
Your modulating boiler is electronically adjusted and ignited.
• It is highly efficient.
• It has a sealed chamber.
Unlike traditional boilers, your condensing boiler makes it possible to recover energy by
condensing the water vapour contained in the flue gas. This means that, with equal heat
production, it consumes less gas, and the flue gas contains fewer substances that are
harmful to the environment.
The materials used and the control systems offer safety, high levels of comfort and energy
savings so you can appreciate the maximum advantages of autonomous heating.
The manual must be read carefully to ensure rational and safe use of the boiler. It must
be stored with care as it may be necessary to consult it in the future. If the unit is trans-
ferred to another owner, the manual must accompany the boiler.
The first ignition must be carried out by one of the authorised service centres, which
validates the warranty from the date on which it is performed.
The manufacturer declines all liability for translations of this manual from which incorrect
interpretations may result. It cannot be considered responsible for failure to observe the
instructions contained in this manual or the consequences of any actions that have not
been specifically described.
After removing the packaging, make sure that the appliance is not damaged.
If damaged do not install or start up the appliance as it may be dangerous.
Contact your retailer or the nearest authorised service centre.
Installation must be carried out by qualified personnel who are responsible for compli-
ance with all applicable national and local laws and standards:
• the suitability of the installation site;
• the robustness of the wall intended for installation;
• the distance of the appliance from walls and surrounding objects;
• correct hook-up to the gas system;
• correct and safe set-up of the of air supply and combustion products evacuation sys-
tem;
• correct hook-up to the electrical power supply and earth circuit;
• compliance with the technical specifications.
The boiler is used to heat water to a temperature that is lower than boiling point, and
must be connected to a heating system and/or a domestic hot water distribution network
that is compatible with its performance and power.
The boiler must be supplied with Methane gas (G20) or LPG (Propane G31).
The condensate discharge must be connected to the residential condensate outlet duct
and it must be possible to inspect it (UNI 11071 and related standards).
- 2 -
IMPORTANT
DURING INSTALLATION
Advertisement
Table of Contents
