Epson DFX-5000+ Service Manual page 156

Pull Tractor Sensor Position Adjustment
This section describes the pull tractor sensor position adjustment. Ifthe sensor
position is incorrect, the sensor is always on. When you replace or disassemble
the platen, rear paper guide, platen roller shaft, tension roller shaft, or pull
tractor sensor, perform this adjustment. Figure 4-4 illustrates the pull tractor
sensor position adjustment.
When you assemble the pull tractor sensor or rear paper guide, check the
following items:
Verify that the pull tractor sensor lever is touching the rear paper guide frame,
but the sensor is off.
approximately .08 inches (2 mm).
Figure 4-4. Pull Tractor Sensor Position Adjustment
EPSON DFX-5000+ Service Manual
Adjustments
4-5