Epson DFX-5000+ Service Manual page 118

Disassembly and Assembly
Removing the C117 MAIN Board Assembly
1. Remove the bottom panel assembly. (Refer to Removing the Bottom Panel
Assembly, on page 3-17.)
2. Disconnect connectors CNl and CN3.
3. Remove the 5 CPB (M3 x 11) screws and 2 CPN (0) (M3 x 8) screws securing
the Cl 17 MAIN board assembly and remove the board.
Figure 3-23. Removing the Cl17 MAIN Board Assembly
When you install the C117MAIN board assembly,perform thefollowing adjustments,
described in Chapter 4:
Removing the AC Inlet
1. Remove the C117 power supply board assembly. (See Removing the Cooling
Fun and C117 Power Supply Assembly, on the previous page.)
2. Remove the C117 MAIN board assembly, as described in the section above.
3. Remove the 3 CPS (M3 x 8) screws and 1 CPB (0) (M4 x 5) screw securing the
earth plate to the bottom panel assembly and remove the earth plate.
3-22
Adjustment Required
EPSON DFX-5000+ Service Manual
Board