Table of Contents
Advertisement
2
Installation
You can install the FI-30 Wind Data in three different ways:
The wind transducer connected directly to the FI-30 Wind Data instrument
By using the connection kit when both log and wind transducers are installed with a
single Wind Data.
The installation may also include a FI-30 Server where all transducers may be
connected. All data including power will pass along one cable.
The installation includes 6 major steps:
1. Read the installation and operation manual.
2. Plan where to install the transducers and instruments.
3. Run the cables.
4. Install the transducers and instruments.
5. Take a break and admire your installation.
6. Learn the functions and calibrate your system.
Before you begin drilling ... think about how you can make the installation as neat
and simple as your boat will allow. Plan where to position the transducers, Server
and instruments. Think about leaving space for additional instruments in the future.
A few "do nots" you should consider:
Do not cut the cables too short. Allow extra cable length at the Server so
it can be disconnected for inspection without having to disconnect all
attached cables.
Do not place sealant behind the display. The instrument gasket eliminates
the need for sealant.
Do not run cables in the bilge, where water can appear.
Do not run cables close to fluorescent light sources, engine or radio
transmitting equipment to avoid electrical disturbances.
Do not rush, take your time. A neat installation is easy to do.
The following material is needed:
Wire cutters and strippers.
Small and large Philips and small flat head screw driver.
Hole saw for the instrument clearance hole 63 mm (2½ ").
1
5 mm (
/
") drill for the mounting holes.
4
Plastic cable ties
If you are doubtful about the installation, obtain the services of an experienced
technician.
8
Advertisement
Table of Contents
