List Of Messages - Canon PICTBRIDGE DC220 Instruction Manual

102 Trouble?
Memory Card Operation
Problem
Memory card cannot be
inserted.
Memory card cannot be
recorded.
Memory card cannot be played
back.
Image cannot be erased.
" " flashes in red.
Printing
Problem
The printer is not operating
even though the camcorder
and printer are correctly
connected.

List of Messages

Message
SET THE TIME ZONE,
DATE AND TIME
CHANGE THE BATTERY
PACK
CANNOT ENTER THE
STANDBY MODE NOW
UNABLE TO RECOGNIZE
THE RECORDING MODE
OF THE DISC
Memory card was not facing the correct direction. Turn the
memory card over and reinsert it.
Memory card is full. Erase still images to free some space or
replace the memory card.
Memory card was not initialized. Initialize the memory card.
The folder and file numbers have reached their maximum value.
Set [FILE NOS.] to [RESET] and insert a new memory card.
Insert a memory card.
Set the camcorder to
Make sure the memory card is selected as the media for still
images.
Image is protected. Cancel the protection.
Card error occurred. Turn off the camcorder. Remove and
reinsert the memory card. Initialize the memory card if flashing
persists.
Disconnect the USB cable and turn off the camcorder and the
printer. After a short while, turn them on again, set the
camcorder to
You have not set the time zone, date and time. This message
appears each time you turn the power on until you set the time
zone, date and time.
Battery pack is exhausted. Replace or charge the battery pack.
The camcorder cannot enter the Quick Start standby mode while
the disc is being recognized after first inserting it or if the remaining
battery charge is too low.
The disc may not be recognized by this camcorder if it was
initialized with a different device.
You inserted a disc recorded in a different Television System (PAL
or SECAM).
Solution
.
Solution
mode and restore the connection.
Explanation
28
73
76
50
28
41
37
75
76
–
32
23
38
–
–