Canon PICTBRIDGE DC220 Instruction Manual page 104

104 Trouble?
Message
• ACCESS ERROR
• DISC ACCESS FAILURE
CHECK THE DISC
DISC COVER IS OPEN
NO DISC
LOADING THE DISC
AVOID MOVING THE
CAMCORDER
UNABLE TO RECOVER
DATA
DISC FULL
TASK IN PROGRESS
DO NOT DISCONNECT
THE POWER SOURCE
NO CARD
NO IMAGES
CARD ERROR
CARD FULL
THE CAMCORDER IS SET
TO STILL IMAGE MODE
NAMING ERROR
OPERATION CANCELED
TRANSFER ORDER
ERROR
There was an error when reading the disc or attempting to write
onto it. Try cleaning the disc or replace it.
This message can also appear if condensation has formed. Wait
until the camcorder dries completely before resuming use.
The disc may not be loaded correctly. Try removing the disc and
reinserting it.
Verify the disc is correctly inserted and close the disc cover.
No disc is loaded. Insert a disc.
This message can also appear if condensation has formed. Wait
until the camcorder dries completely before resuming use.
The disc is being read. Wait before you start recording.
Try not to move the camcorder while the image is being recorded.
Could not recover a corrupted file.
This message can also appear if condensation has formed. If you
suspect condensation is the reason, do not initialize the disc and
wait until the camcorder dries completely before resuming use.
The disc is full (" END" flashes on the screen). Delete some
recordings (DVD-RW in VR mode) to free some space or replace
the disc.
The camcorder is updating important file allocation data on the disc.
Do not disconnect the compact power adapter or remove the
battery pack.
Memory card not is inserted into the camcorder.
No images are recorded on the memory card.
A memory card error occurred. The camcorder cannot record or
display the image.
If the message disappears after 4 seconds and "
turn the camcorder off, remove the card and reinsert the card. If
" " changes to green, you can continue recording/playback.
Memory card is full. Erase some images to free some space or
replace the memory card.
You pressed the Start/Stop button while recording still images
( mode).
The folder and file numbers have reached their maximum value.
Set the [FILE NOS.] option to [RESET] and initialize the disc or
memory card, erase all the images on the memory card or replace
the disc.
There was a problem with the disc or memory card while copying
still images between them.
You attempted to set more than 998 transfer orders.
Explanation
" flashes red,
108
110
26
26
26
110
–
–
–
110
26
69
–
28
–
–
73
–
–
–
91