Canon PICTBRIDGE DC220 Instruction Manual page 105

Message
TOO MANY STILL IMAGES
DISCONNECT USB CABLE
COPYRIGHT PROTECTED
DUBBING RESTRICTED
Direct Print Related Messages
NOTES
About Canon PIXMA/SELPHY DS Printers: If the printer's error indicator flashes or an error message
appears on the printer's operation panel, refer to the printer's instruction manual.
Message
PAPER ERROR
NO PAPER
PAPER JAM
INK ERROR
NO INK
LOW INK LEVEL
INK ABSORBER FULL
• FILE ERROR
• CANNOT PRINT!
COULD NOT PRINT X
IMAGES
SET PRINT ORDER
PRINT ORDER ERROR
CANNOT TRIM
READJUST TRIMMING
PRINTER ERROR
Disconnect the USB cable and decrease the number of still images
on the memory card or disc to less than 1800. Images cannot be
erased from a DVD-R/DVD-R DL or DVD-RW disc recorded in
VIDEO mode.
If a dialog appeared on the computer screen, close it and then
reconnect the USB cable.
You attempted to record copyright-protected contents.
May also appear when an anomalous signal is received while
recording form the analog video input.
There is a problem with the paper. The paper is not correctly loaded or the
paper size is wrong.
Alternatively, if the paper output tray is closed, open it to print.
Paper is not correctly inserted or there is no paper.
The paper jammed during printing. Select [STOP] to cancel printing. After
removing the paper, set some paper again and retry printing.
There is a problem with the ink.
The ink cartridge is not inserted or is out of ink.
The ink cartridge needs to be replaced soon. Select [CONTINUE] to restart
printing.
Select [CONTINUE] to resume printing. Consult a Canon Service Center
(refer to the list included with the printer) to replace the ink absorber.
You attempted to print an image that was recorded with another
camcorder, with a different compression, or was edited on a computer.
You attempted to use the print order settings to print X images that were
recorded with another camcorder, with a different compression or were
edited on a computer.
No still image on the memory card has been marked with a
You attempted to set more than 998 still images in the print order.
You attempted to trim an image that was recorded with another camcorder.
You changed the print style after you set the trimming settings.
Cancel printing. Turn off the printer and turn it back on. Check the printer
status. If the error still persists, refer to the printer's instruction manual and
contact the appropriate customer support center or service center.
Explanation
Explanation
Trouble? 105
–
82
print order.