Omron F10-C20 Instruction Sheet page 8

A.T.ON WD TMR ≠ LINE
A.T.OFF NM ＝
RS-232C
/422
・Model Size
WD：Wide mode
NM：Normal mode
Normal mode
Detection Range: Teaching Area:
Shows the range of Registers this range
the detection area. as the model.
Use wide mode if the pattern in one direction is comparatively long, e.g., a production date.
The measuring time for wide mode, however, takes three times longer than Normal Mode, as the
pattern is processed as three models instead of one.
All the DIP switch pins are set to OFF
at the factory.
Wide mode
Teaching area:
Divedes the
pattern into three,
and registers it as
three models.
Model 1 Model 2 Model 3
detection detection detection
range range range
9
A.T.ON WD TMR ≠ LINE
RS-232C
A.T.OFF NM ＝
/422
All the DIP switch pins are set to OFF
at the factory.
OFF Delay Timer
TMR：Delays the output operation
when the control output goes from
ON to OFF(Default value is 40ms.
Refer to the Operation Manual for
the Unit for changing procedure).
No Marking：Timer OFF.
Matching/Not Matching
≠：
Output ON when object does
not match registered model.
＝：
Output ON when object
match registered model.
External Input
(F10-C50/C55 only）
LINE：
Executes external input in
RUN mode via input line.
RS-232C/422：
Executes external
input in RUN mode via serial
communications.
10