Omron V600-HA Manual

Intelligent Flag I/II
V600-HA
Innovative RFID Electronic Flags to
Replace Mechanical Flag and Kanban
Systems
• Doesn't need a program and can be used like a sensor.
• Advanced line construction at minimal cost.
• Saves space.
• Precise installation not required (Transmission distance:
100 mm max.).
• A verification function provided on multi-functional type.
• Addition of 16-bit models to the series responds to applica-
tions from Kanban to quality control.
• Equipped with a wiring reduction mode and communications
parity check function (16-bit models).
• Both NPN and PNP output available.
• FCC certified.
Ordering Information/Specifications
■ Amplifier
Type
Item Model V600-HAR91
Power supply 24 VDC ±10%, ripple (p-p): 10%
Current consumption 130 mA max.
Input Transistor output or contact output
Short-circuit current: 3 mA (typical) (IN terminal and 0-V short-circuit)
OFF voltage:
ON voltage:
Input impedance:
Applied voltage:
Output NPN open collector
output, 20 mA max. at
30 VDC, residual volt-
age: 2 V max.
Diagnostic functions Checks for CPU errors and transmission errors
Insulation resistance 50 MΩ max. (at 500 VDC) between cable terminals and case
Dielectric strength 500 VAC, 50/60 Hz for 1 min between cable terminals and case (leakage current: 1 mA max.)
2
Intelligent Flag I/II
Read-only (8-bit)
V600-HAR81
15 to 30 VDC
0 to 5 VDC
8.2 kΩ
30 VDC max.
PNP open collector NPN open collector
output, 20 mA max. output, 20 mA max. at
at 30 VDC, residual 30 VDC, residual volt-
voltage: 2 V max. age: 2 V max.
V600-HA
Multi-functional (8-bit)
V600-HAM91 V600-HAM81
PNP open collector out-
put, 20 mA max. at 30
VDC, residual voltage: 2 V
max.
Read-only (16-bit)
V600-HAR92
Transistor output
OFF voltage:
15 to 30 VDC
Input impedance:
8.2 kΩ
Short-circuit current:
3 mA (typical) (for 0-V short-circuit of
INHIBIT/TRG)
ON voltage:
0 to 5 VDC
Applied voltage:
30 VDC max.
NPN open collector output, 20 mA
max. at 30 VDC, residual voltage: 2 V
max.