4.8 Printing Test Data
Tip: To avoid printing errors, it is important to select the
correct protocol per Section 3.5.8 before saving data.
Turn ON the prnter. Refer to the printer's instruction manual for detailed
operation and maintenance information.
If not already done, set the prnter parameters as follows:
• Data: 8 bts
• Baud: 9600
Algn the prnter wth the top of the analyzer as shown n Fgure 4-1.
The next step n the prntng procedure depends on the model of the ana-
lyzer, and whether the operator desres to prnt only the current test data,
or all stored test data startng wth the most recent. Perform the appropr-
ate procedure below:
Model 100 – Print Current Test Data
Wth the analyzer n ts Run Mode, begn prntng by pressng the hOlD
button twice.
Model 105/110/120/125 – Print Current Test Data
1. Wth the analyzer n ts Run Mode, press the hOlD button twice to
dsplay the Prnt Screen.
2. Press eNTeR to start prntng.
Model 105/110/120/125 – Print All Test Data
1. Wth the analyzer n ts Run Mode, press the hOlD button twice
to dsplay the Prnt Screen. Then press the button to dsplay the
Prnt All Screen.
2. Press eNTeR to start prntng.
26
Fyrite Pro
• Party: None
• Handshakng: X-on/X-off
Instruction 24-9395