Table of Contents
Advertisement
Fault Diagnosis
1. User Troubleshooting Guide
The Mira Advance ATLP pumped electric shower is fully performance tested after
assembly. In the unlikely event that you experience problems with the appliance,
then the following procedures will enable basic troubleshooting before contacting
the competent tradesperson responsible for installing the shower.
Warning! There are no user serviceable components beneath the cover of the
appliance.
Only a competent tradesperson should remove the front cover. We recommend any
maintenance work is carried out by a Mira service Engineer or qualified tradesperson.
Reset the Shower
This is the first solution to the appliance not operating (i.e. the reset light is
illuminated).
DO NOT switch on the appliance if there is a possibility that the water in the shower
is frozen!
1. Isolate electrical supply.
3. Wait for the Start/Stop button to stop
pulsing, then operate the appliance,
refer to section: 'Operation, Using
the Shower'.
2. Restore power to the appliance. The
appliance may "beep" and the Start/
Stop button pulse for 15 seconds.
4. If the failure continues after resetting,
there are a few basic supply checks
that can be performed.
10
15 secs
Advertisement
Table of Contents
