Table of Contents
Advertisement
Indicator Display
No lights or beeps
Shower temperature is not hot enough.
OR
OR
12
Possible Cause/Rectification
Problem with Electrical supply.
1.
Make sure there is power to the appliance.
2.
Reset the shower.
3.
Contact qualified electrician to investigate
the cause.
Maximum temperature is set too low.
1.
Adjust Maximum Temperature, refer to
section: 'Set Maximum Temperature
and Commissioning Cycle' in the 'Mira
Advance ATLP Pumped Electric Shower
Installation Guide'.
Problem with incoming water supply. Hose or
showerhead blocked. Temperature is too high and/
or pressure is too low.
1.
Water supply may correct itself within a few
minutes.
2.
The showerhead may be blocked, refer to
the fault diagnosis section in your shower
fittings installation and user guide.
3.
The shower hose is kinked or blocked.
4.
If the warning persists during further use,
check all isolator valves are fully open and
Reset/Recommission the shower.
5.
If the warning still persists, there is a
problem with the water supply. Contact a
competent tradesperson who can further
investigate the cause.
Automatic shutdown to protect against unsafe
showering. Caused by problem with either the
appliance or the electrical/water supply.
1.
Reset the shower.
Appliance has been incorrectly shut down.
1.
If a 2 second beep is heard and the
Start / Stop light pulses after the power
supply is restored to the shower this
indicates incorrect shower shutdown on
previous use. The pulsing light will stop
after 20 seconds and the shower can then
be used normally.
Advertisement
Table of Contents
