Table of Contents
Advertisement
3. Using the Shower
Refer to section: 'Important Safety Information' first.
1. With the electrical supply turned on,
push Start/Stop.
3. Check water temperature before
entering shower.
5.
Powering down the appliance:
Caution! Isolating power without
shutting down the appliance using
the Start/Stop button, and not
waiting for the flow to stop, will
result in a temporary malfunction.
Always follow the correct shut
down procedure.
7. The shower will purge water from its
tank for a few seconds.
Important! DO NOT isolate the
power to the appliance.
+
_
9
2. Select the desired flow by pushing
either once or twice.
4. Allow 10-15 seconds for any
temperature adjustments to reach
the showerhead.
6. Push Start/Stop to turn off the
appliance. The pulsing light and
"beep" indicates that the appliance
is shutting down.
Important! DO NOT isolate the
power to the appliance.
8. Wait until the water has stopped
flowing and turn off the power to the
appliance, residual water may drain
over a few minutes.
+ +
_
Advertisement
Table of Contents
