Onkyo TX-8390 Instruction Manual page 87

3. Audio Adjust
„ 1. Volume
Change the Volume settings.
Setting Item Default Value
Mute Level -∞ dB
Maximum Volume Off
Power On Volume Last
Headphone Level 0.0 dB
4. Source
„ 1. IntelliVolume
Adjust the volume level difference between the devices connected to the unit.
Select the input selector to configure.
Setting Item Default Value
IntelliVolume 0.0 dB
Setting Details
Set the volume lowered from the listening volume
when muting is on. Select a value from "-∞ dB",
"-40 dB" and "-20 dB".
Set the maximum value to prevent the volume from
becoming too loud. Select a value from "Off", and
"50" to "99".
Set the volume level of when the power is turned
on. Select a value from "Last" (Volume level before
entering standby mode), "Min", "0.5" to "99.5" and
"Max".
• You cannot set a higher value than that of
"Maximum Volume".
Adjust the output level of headphones. Select a
value between "-12.0 dB" and "+12.0 dB".
Setting Details
Select from "-12.0 dB" to "+12.0 dB". Set a
negative (-) value if the volume of the target device
is larger than the others and a positive (+) value if
smaller. To check the audio, start playback of the
connected device.
• This function is not effective in ZONE 2.
Contents Connections
≫
„ 2. Name Edit
Set an easy name for each input. The set name appears on the main unit's
display. Select the input selector to make the setting.
Setting Item Default Value
Name Edit Input name
• To name a preset radio station, press TUNER on the remote controller, select AM (North
American models)/FM, and select the preset number. (Preset names cannot be given to
DAB stations (European models))
• This cannot be set if the "NET" or "BLUETOOTH" input is selected.
87
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫
Setting Details
1. Select a character or symbol with the cursors,
and press ENTER.
Repeat this operation to input up to 10
characters.
"A/a": Switches between upper and lower cases.
(Pressing MODE on the remote controller also
toggles between upper and lower cases)
"←" "→": Moves the cursor in the arrow direction.
" ": Removes a character on the left of the
cursor.
" ": Enters a space.
• Pressing CLR on the remote controller will
remove all the input characters.
2. After inputting, select "OK" with the cursors, and
press ENTER.
The input name will be saved.
To restore the name to the default value, press
CLR on the remote controller on the input screen.
Then while nothing is entered, select "OK", and
press ENTER.
≫