Onkyo TX-8390 Instruction Manual page 23

„ 2.1 Channel System (Bi-wiring the Speakers)
a
a: 22° to 30°
1,2 Front Speakers
3 Powered Subwoofer
You can connect speakers that support bi-wiring to this unit. Connect the treble and bass correctly. Be sure to remove
the jumper bar connecting between the woofer jacks and tweeter jacks of the Bi-wiring supported speakers. Refer to the
instruction manual of your speakers as well.
• As shown on the illustration, the wiring terminals of SPEAKERS B are connected to the tweeter and SPEAKERS A are
connected to the woofer. However, wiring them the other way around is also possible.
Contents Connections
≫
For high-
frequency
For low-
frequency
23
Playback
≫
"Speaker Setup" settings during
„
Initial Setup (
Speaker Setup
Subwoofer
Speaker B
Zone 2 Lineout
Speaker Impedance
Specifies whether the powered subwoofer is connected or not.
• Subwoofer:
(Select "No" when not using a
Subwoofer)
• Speaker B:
• Zone 2 Lineout/(Preout):
value (
• Speaker Impedance:
4 ohms: When any of the
connected speakers have 4
Ω or more to less than 6 Ω
impedance.
6 ohms or
connected speakers all have 6
Ω or more impedance.
Front Panel≫ Rear Panel≫ Remote≫
Setup
≫ ≫
p101)
Yes < >
Bi-Wiring
Zone 2
6ohms or above
Next
Yes
Bi-Wiring
Any
p85)
above: When the