Onkyo TX-8390 Instruction Manual page 77

Switching the HDMI 4K Signal Format Input and Output by this Unit
When the AV Component connected to this unit, such as a TV or player, and the
HDMI cable (*) supports the high-definition 4K signal formats (4K 60p 4:4:4, 4:2:2
and 4K 60p 4:2:0 10bit), switch the setting value from "Standard" (default value)
to "Enhanced".
(*)Premium High Speed HDMI Cable or Premium High Speed HDMI Cable
with Ethernet that have the "PREMIUM Certified Cable" label attached to the
packaging.
Perform the following procedure when the unit is on.
1. While pressing ZONE 2 on the main unit, press the
the current setting on the display. While this is being displayed, while pressing
ZONE 2, repeatedly press the
Standard
(
Default
)
Value
Select when the AV component connected to this unit,
such as a TV or player, supports the standard 4K signal
format (4K 60p 4:2:0 8 bit).
cursor button to display
cursor button to switch the setting.
Contents Connections
≫
Enhanced
2. To exit the settings, release your finger. After a few seconds, the display goes
out and the switching is complete.
Settings and the corresponding resolutions
4K (3840×2160p) 24/25/30 Hz
4K SMPTE(4096×2160p) 24/25/30 Hz
4K (3840×2160p) 50/60 Hz
4K SMPTE(4096×2160p) 50/60 Hz
77
Front Panel≫ Rear Panel≫ Remote≫
Playback
≫
Select when the AV component connected to this unit,
such as a TV or player, and the HDMI cable (*) supports
the high-definition 4K signal formats (4K 60p 4:4:4, 4:2:2
and 4K 60p 4:2:0 10 bit).
• There may be some image disruption depending on
the connected component and the HDMI cable. If this
occurs, switch to "Standard".
8 bit
RGB/
YCbCr4:4:4
10/12 bit
YCbCr4:2:2 12 bit
RGB/
8 bit
YCbCr4:4:4
YCbCr4:2:2 12 bit
8 bit
YCbCr4:2:0
10/12 bit
Setup
≫ ≫
Enhanced Standard