Onkyo TX-8390 Instruction Manual page 15

1. DIGITAL IN OPTICAL/COAXIAL jacks: Input TV or AV component digital audio
signals with a digital optical cable or digital coaxial cable.
2. TUNER AM/FM terminal (North American models): Connect the supplied
antennas.
TUNER DAB/FM terminal (European models): The supplied antenna is
connected.
3. HDMI OUT jacks: Transmit video signals and audio signals with an HDMI
cable connected to a monitor such as a TV or projector.
4. Wireless antenna: Used for Wi-Fi connection or when using a BLUETOOTH
enabled device. Adjust the angles according to the connection status.
5. IR IN/OUT terminals: Connect a remote control receiver unit. (
6. REMOTE CONTROL jack: An Onkyo product with RI ("Remote Interactive")
jack can be connected and synchronized with this unit. (
7. HDMI IN jacks: Transmit video signals and audio signals with an HDMI cable
connected to an AV component.
8. ETHERNET port: Connect to the network with a LAN cable.
9. USB port: Connect a USB storage device to play music files. (
can also supply power (5 V/1 A) to USB devices with a USB cable.
10. AC INLET: Connect the supplied power cord.
11. GND terminal: Connect the ground wire of the turntable.
12. AUDIO IN jacks: Input AV component audio signals with an analog audio
cable.
13. ZONE 2 LINE OUT jacks: Output audio signals with an analog audio cable
connected to a pre-main amplifier in a separate room (ZONE 2).
PRE OUT FRONT jacks: Connect to a power amplifier. (
14. SUBWOOFER PRE OUT jacks: Connect a powered subwoofer with a
subwoofer cable. Up to two powered subwoofers can be connected. The same
signal is output from each SUBWOOFER PRE OUT jack.
15. SPEAKERS terminals: Connect speakers with speaker cables. (North
American models support banana plugs. Use a plug 4 mm in diameter. Y plug
connection is not supported.)
Contents
≫
p34)
p29)
p47) You
p24)
15
Connections Playback
≫
Front Panel≫ Rear Panel≫ Remote≫
Setup
≫ ≫