To Replace The Sealing Strips; The Charging Station; To Mount Screws In Plastic - Husqvarna GARDENA SILENO MINIMO Workshop Manual

5.16.2 To replace the rear wheel
1. Turn the product up side down and put it on a soft
and clean surface to prevent damage to the product.
2. Push the 2 clips and pull the rear wheel up.
3. Install in the opposite sequence.

5.17 To replace the sealing strips

There is a sealing strip between the upper chassis and
lower chassis in the product.
CAUTION: A 5 mm sealing strip must be used.
Sealing may be deficient if the wrong sealing
strip is used.
1. Start by laying one end of the sealing strip in line
with the marking on the chassis.
2. Continue laying the sealing strip clockwise around
the lower chassis.
3. Lay the other end of the sealing strip above the first
end and then out of the channel. Fasten the sealing
strip in the retainer.
20 - Repair instructions

5.18 The charging station

5.18.1 To replace the charging tower
The charging tower consists of the contact plates and
the charging station's circuit board. These cannot be
replaced separately. The entire charging tower must be
replaced as a unit.
When the product's battery does not recharge or cannot
contact the charging station, this may be due to worn
contact plates in the charging station. Also check the
charging plates on the product.
1. Disconnect the power supply.
2. Disconnect all cables from the charging station.
3. Release the 2 clips with a flat screwdriver and pull
up the charging tower.
4. The cap is attached with one clip. Remove it by
gently lifting one side of the cap.
5. Fit the cap to the new charging tower.
6. Refit the charging tower on the baseplate.
7. Connect all cables to the charging station.
8. Connect the power supply.

5.19 To mount screws in plastic

CAUTION: If the screws are mounted
incorrectly, there is a risk of damaging the
threads in the plastic and thereby shortening the
1595 - 001 - 01.02.2021