Husqvarna GARDENA SILENO MINIMO Workshop Manual page 27

Messages
Number Message Cause
33 Mower til- The product is tilted more than the maxi-
ted mum angle.
35/36 Wheel Grass or other object has wrapped around
motor the drive wheel.
overloa-
ded, right/
left
37 Charging The battery is being charged with too high
current current.
too high
38 Electron- Communication problems with the cutting
ics prob- system.
lem
50 Guide not The product is no longer receiving signals
found from the guide wire.
58 Tempora- Wrong type of battery.
ry battery
problem
60 Tempora- Battery temp sensor defective.
ry battery
problem
Wrong type of battery.
62 Tempora- The temperature in the battery is too high
ry battery or too low to enable normal operation.
problem
75 Loop sig- New loop signal sucessfully changed.
nal cre-
ated
76 Connec- Failed to change loop signal.
tion NOT
changed
78 Slipped The product has got caught in something.
The working area includes a steep slope.
The guide wire is not laid at an angle on a
slope.
81 Safety The keypad is faulty.
function
faulty
NA Needs The product is set to the
manual operating mode.
charging
1595 - 001 - 01.02.2021
Action
Move the product to a flat area.
Check the drive wheel and remove any objects.
Fault in the power supply, or wrong type of power
supply or charging station is being used.
Restart the product by switching off the ON/OFF
button, wait 10 seconds and then switch on the
ON/OFF button.
Replace the main circuit board. Refer to
place the main circuit board on page 16 .
Check connection of guide wire to charging sta-
tion. To locate a break in a wire, refer to
break in the boundary loop on page 31 .
Use only original batteries recommended by the
manufacturer.
Replace the battery. Refer to
tery on page 17 .
Use only original batteries recommended by the
manufacturer.
No action. When the temperature is back within
the allowed limits the product will revert to normal
operation.
No action.
Try several times to create New loop signal. If
problem remains, replace the battery.
Free the product and rectify the reason for the
lack of drive. If it is due to wet grass, wait until the
lawn has dried before using the product.
Check the maximum guaranteed slope. Steeper
slopes should be isolated.
Lay the guide wire at an angle across the slope.
Restart the product. If the problem remains, re-
place the keypad, main circuit board or cabling.
Secondary area
Put the product in the charging station. This be-
haviour is normal and no further action is re-
quired.
To re-
To find a
To replace the bat-
Troubleshooting - 27