To Replace The Sealing Strips - Husqvarna Automower 305 Workshop Manual

3. Make sure the plug is screwed in completely so that
a good seal is obtained.
CAUTION: Tighten by hand so as not to
damage the plastic.
4. Fit the plastic parts with the accompanying screw
instead of the old plastic screw.

6.20 To replace the sealing strips

There are 3 sealing strips in the product. One between
the center console and the upper chassis, one between
the cutting system and the upper chassis and one
between the lower and upper chassis. Both sealing
strips must be replaced using the same technique.
CAUTION: A 5 mm sealing strip must be used.
Sealing may be deficient if the wrong sealing
strip is used.
1. Start by laying one end of the sealing strip in line
with the marking on the chassis.
2. Continue laying the sealing strip clockwise around
the lower chassis.
34 - Repair instructions
3. Lay the other end of the sealing strip above the first
end and then out of the channel. Fasten the sealing
strip in the retainer.
1414 - 001 -