To Replace The Cutting Module; The Wheel Motors - Husqvarna GARDENA SILENO MINIMO Workshop Manual

CAUTION: There must not be any loose
corners or air bubbles as this can cause dirt
and moisture to get in under the keypad.
6. Reconnect the new keypad to the main circuit board.
7. Install in the opposite sequence.

5.15 To replace the cutting module

1. Remove the lower chassis. Refer to
chassis on page 12 .
2. Remove the 2 screws for the blade disc.
3. Remove the 3 screws for the cutting motor.
4. Lift up and remove the cutting motor.
5. Install a new cutting motor.
6. Install in opposite sequence.
CAUTION: Make sure that the gasket seals
properly.

5.16 The wheel motors

The 2 wheel motors are brushless DC motors. The
motors are supplied as a unit together with gearbox,
wheel motor end cover, gasket, hub and cable.
Right and left wheel motors are identical and have the
same article number as spare parts. The motors have to
be replaced if they are faulty.
1595 - 001 - 01.02.2021
5.16.1 To replace the wheel motor
1. Remove the upper chassis. Refer to
2. Disconnect the wheel motor cable from the main
The lower
3. Remove the hub cap using a flat screwdriver.
4. Remove the nut and washer holding the wheel in
5. Remove the wheel motor by loosing the 4 screws
6. Fit the new wheel motor and fasten the screws (Torx
7. Install in the opposite sequence.
install the upper chassis on page 14 .
CAUTION: Always disconnect the power
cable first to prevent current spikes that may
harm the circuit boards or the battery.
board.
place and remove the wheel.
(Torx 20) in the wheel motor bracket.
20) with the recommended torque.
To remove and
Repair instructions - 19