Husqvarna GARDENA SILENO MINIMO Workshop Manual page 25

Messages
Number Message Cause
5 Loop sen- The main circuit board is faulty.
sor prob-
lem, rear
8 Wrong Incorrect PIN code has been entered.
PIN code
9 Trapped The product is stuck in a small area behind
a number of obstacles.
10 Upside The product is leaning too much, or has
down turned over.
11 Low bat- The product cannot find the charging sta-
tery tion.
The battery is spent.
12 Empty Refer to number 11 above.
battery
15 Mower lif- The lift sensor has been activated due to
ted the product getting stuck.
One of the lift senor magnets is inverted or
missing.
The lift sensor is faulty.
16 Stuck in There is an object in the way of the prod-
charging uct preventing it from leaving the charging
station station.
The product slides on the baseplate.
17 Charging An object is obstructing the product.
station
The baseplate is bent.
blocked
The contact between the charging plates
and contact plates may be poor and the
product has made a number of attempts to
charge.
18/19 Collision The front wheels on the product are
sensor blocked.
problem
rear/front
20/21 Wheel Grass or other object has wrapped around
motor the drive wheel.
blocked,
right/left
1595 - 001 - 01.02.2021
Action
Check the levels for the A signal. Refer to
eck service tool on page 9 .
Enter the correct PIN code.
Check if there are any obstacles which make it
hard for the product to move on from this location.
Turn the product the right way up and rectify the
reason.
Break in the guide wire. Check the LED on the
charging station. Refer to
30 .
Change the position of the guide wire. Refer to
stallation - Installation of the guide wire in the Op-
erator's manual.
Check the installation settings about how to find
the charging station.
Perform a battery test. Refer to
10 .
Refer to number 11 above.
Free the product and rectify the reason.
Check the magnet. Refer to
sensor circuit board on page 15 .
Check the lift sensor. Refer to
sensor circuit board on page 15 .
Remove the object.
Clean the baseplate.
Remove the object.
Ensure that the baseplate is placed on level
ground.
Put the product in the charging station and check
that the charging plates and contact plates make
good contact.
Free the product and rectify the reason.
Check the drive wheel and remove any objects.
Autoch-
Loop signal on page
In-
Auto test on page
To replace the front
To replace the front
Troubleshooting - 25