Table of Contents
Advertisement
5.4 The cutting system
The cutting system is structured mechanically around
the following modules:
1. Cutting module
2. Blade disc
5.5 To mount screws
It is important to mount the screws correctly. Incorrect
mounted screws may harm the product. The screw
dimension is Torx 20 when there is no other information.
Note: Read the section about how to mount screws in
plastic before starting any maintenance. Refer to
mount screws in plastic on page 20 .
Note: Always use the recommended torque to mount the
Screw fasteners on page 22 .
screws. Refer to
5.6 To remove and install the body system
CAUTION: Clean grass and dirt from the
product before you disassemble it.
1595 - 001 - 01.02.2021
Note: This section describes how to disassemble all
parts of the body. For service or changing of spare parts
all steps may not be needed.
1. Push the ON/OFF button to disable the product. The
2. The top cover is attached to the body by clips. Pull
1
2
3. Put one hand on the upper chassis and remove the
To
4. Locate the 2 positions where the body system is
product is disabled when the indicator lamp is not lit.
the top cover up clockwise by hand and remove it.
rear part of the body with a fast and short pull.
attached.
Repair instructions - 13
Hide quick links:
Advertisement
Table of Contents
