Cutting Height Pedal; Accessories - Husqvarna EZ4624 Operator's Manual

13. Cutting height pedal

The cutting deck height is obtained by pressing the foot
pedal lift arm forward and releasing the transport latch.
Then lower the deck to the preset height. To raise the
deck push forward on the foot pedal lift arm until the
transport latch locks. The cutting height range is from
1½" (38 mm) to 4½" (114 mm) in 1/4" (6.4 mm)
increments. The heights are measured from the ground
up to the blade tip with the engine not running.
To change cutting heights move the pin on the cutting
height plates to the desired height of cut.
IMPORTANT INFORMATION
Always use the high position to transport.
IMPORTANT INFORMATION
In order to obtain an even cutting height it
is important that the air pressure in all four
tires is the same 15 psi (1 bar).

Accessories

For mulching, there is a BioClip attachment available.
This is mounted underneath the mower deck and
consists of control plates and BioClip blades.
CONTROLS
1. Foot pedal
2. Lift arm
3. Height plate
Cut height pedal
3
1
2
25
-
English