General Troubleshooting - Master F-05 User Manual

GENERAL TROUBLESHOOTING

Problem
The device does not start
The running surface is slipping
The running surface is off centre The running surface is not adjusted correctly. Adjust the running surface to being centred.
You hear strange noises
Short circuit or damage to the
power cable on the upper control
Warm up
This stage helps to get the blood flowing around the body and the muscles working properly. It
will also reduce the risk of cramp and muscle injury. It is advisable to do a few stretching exercises
as shown below. Each stretch should be held for approximately 30 seconds, do not force or jerk
your muscles into a stretch - if it hurts, STOP.
Reason
No power supply, or switch is on 'off'. The
treadmill's excess current protection is not
connected.
The running surface is loose.
The rotation axis requires grease,
Damage to the power cable on the upper
control panel,
44
Solution
Connect power supply and switch on the
device.
Connect the excess current protection.
Adjust the running surface according to
section 8. Maintenance.
Apply grease to the rotation axis, Tighten the
appropriate screws
Replace the lower control panel,
EN