Table of Contents
Advertisement
CAUTION
• When Adaptive Cruise Control is operating, the actual vehicle speed is con-
trolled according to the lead vehicle. Therefore, if the RES/SET switch is
pressed to the "RES/+" side and set to a speed higher than the speed of the
lead vehicle, the vehicle will not accelerate; it will maintain a safe following
distance as the first priority. However, because doing so changed the set
vehicle speed, when the lead vehicle is no longer detected (for example, if
you change to a freeway lane with no vehicles in front), the vehicle will accel-
erate to that new set vehicle speed. Change the set vehicle speed while
briefly checking the value shown in the set vehicle speed display on the
EyeSight display.
• When the accelerator pedal is depressed with Adaptive Cruise Control on,
automatic braking control and warnings by Adaptive Cruise Control will not
occur. However, if there is a high risk of collision with an obstacle in front of
the vehicle at this time, the warning and braking control of the Pre-Collision
Braking System may activate.
■ Decreasing the set vehicle speed
●
Using the RES/SET switch
• Push to the "SET/-" side briefly.
Every time the switch is pushed, the set
vehicle speed will decrease to the next 5
mph (5 km/h) decrement.
• Push to the "SET/-" side continuously.
While the switch is being pushed, the set
vehicle speed will decrease in decrements
of 1 mph (1 km/h).
When operating the switch, the set vehicle
speed changes on the combination meter dis-
play.
●
Using the brake pedal
1. Depress the brake pedal to decrease the vehicle speed. Adaptive Cruise Control will be
canceled and
2. When the desired speed is reached, press the RES/SET switch to the "SET/-" side. The
speed at the time of pressing the switch will be set as the new set vehicle speed, and it
appears on the EyeSight display area.
(SET indicator) will be turned off.
Adaptive Cruise Control
S03443
57
Advertisement
Table of Contents
