Husqvarna K1270 II Workshop Manual page 63

1. Remove the carburetor. Refer to
carburetor on page 18 .
2. Push in the lower part of the throttle lock with a V-
jaw adjustable pliers.
3. Lift the lower part of the throttle lock and pull it out
from the pin.
4. Remove the screw and the right handle side.
5. Push out the spindle to the right side. Use a rod with
a diameter of 0.08–1.0 in./2–2.5 mm and minimum 4
in./10 mm in length.
1273 - 001 - 04.11.2019
6. Remove the throttle trigger.
To remove the
7. Push out the spindle to the right side. Use a rod with
8. Remove the throttle control wheel.
9. Remove the wire from the throttle control wheel.
6.16.2 To examine the throttle lock
The throttle lock operates correctly if the throttle is
locked at idle speed.
1. Make sure the throttle cannot be released until the
a diameter of 0.08–1.0 in./2–2.5 mm and
approximately 4 in./10 mm in length.
top handle is pressed.
Repair and servicing - 63