Ignition System - Husqvarna K1270 II Workshop Manual

6.1.7 To examine the starter pawls
Note: Do not lubricate the starter pawls.
1. Make sure the springs work and the starter pawls
move freely. Disassemble and clean, if necessary.
6.1.8 To disassemble the starter pawls
Note: The position of the washer is below the starter
pawls against the flywheel. Make a note of the position
of the springs in relation to the flanges on the flywheel.
• Remove the shoulder screws.
6.1.9 To assemble the starter pawls
CAUTION: The spring must not get caught
between the starter pawl and the flywheel.
1. Push the spring into position in the flywheel.
2. Install the washer, the starter pawl and the shoulder
screw.
26 - Repair and servicing
3. Bend the end of a thin steel wire. Use it to pull the
spring to the mounting on the opposite side.
6.1.10 To install the starter
The starter pawls must come into the correct position
against the starter pulley sleeve.
1. Pull out the rope approximately 0.5 m.
2. Keep this position and set the starter against the
product.
3. Slowly release the rope until the starter pawls come
into the correct position.
4. Tighten the 4 screws on the starter to a torque of 7–
9 Nm.

6.2 Ignition system

6.2.1 Function
The ignition system has no moving parts and it is not
sensitive to moisture and dirt.
It is not necessary to adjust the ignition point.
The product has an overspeed protection rev limiter.
The limit is 9300 rpm.
1273 - 001 - 04.11.2019