Husqvarna K1270 II Workshop Manual page 25

3. Remove the cable pulley.
4. Remove the plate above the return spring with a
screwdriver.
5. Remove the return spring.
WARNING: If the return spring is broken,
put a cloth on top of the plate to prevent eye
injury.
6.1.5 To assemble the starter pulley
The return spring in the starter pulley decreases
vibrations. The spacer sleeve around the center screw is
the top bearing point for the starter pulley.
1273 - 001 - 04.11.2019
Note: Make sure that the spacer sleeve does not fall off.
1. Align the starter pulley notch with the end of the
return spring.
2. Put the center bolt into the starter pulley assembly.
6.1.6 Starter pawls
When the flywheel does not move, the starter pawls are
pushed in the direction of the center by springs. When
the flywheel rotates, the turning force pushes out the
center pawls.
Repair and servicing - 25