Flywheel - Husqvarna K1270 II Workshop Manual

4. Tighten the screw. Connect the cable to the stop
switch.
6.2.10 To assemble the ignition unit
1. Align the magnet on the flywheel with the ignition
unit.
2. Put the air clearance gauge (0.01 in./0.3 mm)
against the magnets. Refer to
overview on page 12 .
3. Put the new ignition unit in position. Push it against
the air clearance gauge while you tighten the
screws. Tighten the screws with a torque of 10–12
Nm.
30 - Repair and servicing
Servicing tools

6.3 Flywheel

6.3.1 To remove the flywheel
Use a Husqvarna flywheel puller. Refer to
tools overview on page 12 .
1. Remove the starter and the lower air duct.
2. Loosen the springs and put the starter pawls in their
outer positions.
3. Put a 13 mm socket on the center screw of the
flywheel.
4. Attach the flywheel puller on the socket with the
screw that is supplied with the flywheel puller.
Servicing
1273 - 001 - 04.11.2019