Husqvarna K1270 II Workshop Manual page 51

use 2 Husqvarna bearing press kits, refer to
tools overview on page 11 .
1. Put the puller plate behind the bearing.
2. Attach the puller unit and press the bearing off from
the crankshaft.
1273 - 001 - 04.11.2019
Servicing
3. Put the crankcase halves against a flat piece of
wood or equivalent. Use a hot air gun around the
bearing, maximum 100°C /212°F.
4. Put the sleeve from the tool kit against the bearing
and hit it with a large plastic mallet.
Repair and servicing - 51