Husqvarna K1270 II Workshop Manual page 57

3. Put the hex key in a vise. Put the head of the screw
on the hex key. Put the socket and cover in position.
Install the washer and the nut.
4. Tighten the nut and pull out the bearing
1273 - 001 - 04.11.2019
6.13.9 To install the belt pulley bearings
1. Put the support plate of the bearings in a vise. Put
the 2 ball bearings on the support plate.
2. Put the belt pulley on top of the belt pulley bearings.
Put the cover and washers on top of the belt pulley.
Put the screw through the assembly.
3. Tighten the screw to push the belt pulley bearing
until the bearings are at the end in the belt pulley.
Note: When you install the clutch, first put the washer on
the crankshaft.
Repair and servicing - 57