Connect The Can Cables - Graco HydroShield WMBL00 Instructions - Parts Manual

Connect Connect the Connect the Air the Air Supply Air Supply Hose Supply
Use a wrench to connect the air supply hose between
the air supply and the air inlet (A) on the isolation
cabinet. The maximum air pressure is 100 psi (0.7
MPa, 7.0 bar). A minimum of 70 psi (0.5 MPa, 5.0
bar) is needed to operate the system.
For best performance use an air supply hose with a
minimum inner diameter of 3/8 inch (10 mm). Do not
use quick disconnect connectors.
Install a bleed type air valve (AV) near the cabinet
to easily turn off the air supply during installation or
service.
Figure 13 Air and Fluid Inlets
3A7312D
Hose to to to the Hose the Cabinet the Cabinet Cabinet Connect the Connect Connect the Fluid the Fluid Fluid Supply Supply Hose Supply
Cabinet Cabinet Cabinet
Use a wrench to connect the fluid supply hose
between the fluid supply and the fluid inlet (F) on the
isolation cabinet. The maximum fluid pressure is 100
psi (0.7 MPa, 7.0 bar).
Note
Do not overtighten as this will rotate the inlet
valve and cause an issue with the flexible
hose on the inside of the cabinet. The valve
outlet on the inside of the cabinet should be
pointed upward.
Note
For the system to function correctly, the inlet
fluid pressure must not exceed the inlet air
pressure.
Consider installing a manual fluid shut-off valve (FV)
close to the cabinet to easily turn off the fluid supply
during installation or service.
Connect the the CAN CAN Cables
Connect Connect the CAN
Connect the Control Area Network (CAN) cables to
the control interface (42) so that the interface can
communicate with the isolation system (1).
1. Connect the power supply CAN cable:
a. Locate the CAN cable attached to the power
supply (47) on the back of the cabinet.
b. Screw the cable into the bottom fitting on
the right side of the cabinet, next to the light
tower.
Figure 14 Controller CAN Cable Connections on
the Cabinet (no Color Change)
Installation
Hose to to to the Hose the the
Cables
Cables
21