Maintenance Screens - Graco HydroShield WMBL00 Instructions - Parts Manual

Setup Menus

Maintenance Screens

Screens
Maintenance Maintenance Screens
Maintenance Maintenance Maintenance 1: 1: 1: Maintenance Maintenance Maintenance Due
Use the Maintenance Due screen to set maintenance
reminders for system components. When the cycle
counters for each item reach these set values, an
advisory is displayed on the screen.
Isolation Valve: Valve: The number of times the isolation
Isolation Isolation Valve:
valve shuttle has moved.
Isolation Valve Valve Seal: Seal: The number of times the seals
Isolation Isolation Valve Seal:
in the housing have been engaged.
Wash Wash Fluid: Wash Fluid: The number of times the wash fluid has Fluid:
been moved through the isolation valve.
Volume: Volume: The total volume (cc) of fluid dispensed Volume:
by the isolation fluid pump between maintenance
events. This value does not account for material that
is pushed through the system in Prime mode.
Pump: Pump: The number of times the isolation fluid pump Pump:
has dispensed fluid.
Pump: The number of days that have passed since
Pump: Pump:
the last stall test was completed successfully. See
Pump Stall Test Procedure, page
Solenoid Solenoid Solenoid Valve: Valve: The number of times the Valve:
solenoid valves have been activated. (All of the
solenoids listed in Status screens 1 and 2. See
Status Screens, page 50.)
60
Due Due Maintenance 2: 2: 2: Pump Maintenance
Use the Pump Stall Test screen to test the isolation
fluid pump for internal and external fluid leaks. During
the Pump Stall Test, the pump position is held for 60
seconds while the system looks for leaks.
61.
Maintenance Pump Stall Pump Stall Test Stall Test Test
3A7312D