Alarm IO PIN Assignment
Note that this function just for EZN1250-S.
Reset Button
Note that this function just for EZN1250-S.
The Reset Button can be used to restore the camera to factory default. When
the camera is powered up, press the Reset Button about 8 seconds to reboot the
camera.
Installation
3.
3.1 EZN Series
1. Drill three holes on the surface according to the screw positions on the
Camera Base. Push the supplied 3 Screw Anchors into the holes. Drill another
hole in the middle within the 3 screw holes if you wish to run the wires into
the surface. Screw the camera to surface using the supplied 3 Screws.
2. Adjust the pan/tilt/rotate angles of the camera by loosen the Pan/Tilt/Rotate
screws using the supplied Hexagon Wrench.
1
Alarm In
2
GND
3
COM
4
Alarm Out
Screw
Screw Anchor
4
Surface