Advertisement
3. Connect the camera to power. You can either connect the camera to a 12VDC
power source or to a PoE switch using the PoE cable.
4. Connect the camera to the network using the supplied Cable Gland Kit.
a. Insert a RJ-45 network cable (without the RJ-45 connector on the one end)
through the supplied Waterproof Ring, Cable Gland, Stopper and Screw
Cap accordingly.
Waterproof Ring
b. Connect the RJ-45 cable to the LAN/PoE Cable of the camera.
LAN/PoE Cable
c. Tightly screw the Cable Gland and Screw Cap to the Rugged RJ-45
Connector Cable.
d. Crimp the RJ-45 connector onto the RJ-45 network cable. Note that the
wires should be placed into the RJ-45 connector based on the following
order (from left to right).
Rotate Screws (both sides)
Cable Gland
RJ-45 Cable
Screw Cap
Cable Gland
Tilt Screw
Pan Screw
Stopper
Screw Cap
5
Advertisement
